Mark Swanson photo

Mark Swanson

Mark Swanson is a Sr. Account Executive at JBC with over 20 years of experience in die-cutting, fabricating, and laminating. When not at work, Mark enjoys spending time with his wife and two daughters, running, and repairing or restoring just about anything with a motor.

Posts:

11/1/2017

Parts Presentation and Die Cutting Costs

arrow-right

Parts presentation is one of three major factors that drives die cutting costs. Are your die cut products presented properly when it’s time to install them?

Die Cutting
Parts Presentation and Die Cutting Costs
10/23/2017

Equipment Usage and Die Cutting Costs

arrow-right

Die cutting costs are driven in part by equipment usage. How can you tell if your die cutter is using the right die cutting equipment for your jobs? Ask JBC.

Die Cutting
Equipment Usage and Die Cutting Costs
10/18/2017

Material Selection and Die Cutting Costs

arrow-right

Material selection drives die cutting costs. Look for newer, higher-performing, or less expensive die cut materials. Avoid over-engineering die cut parts, too.

Die Cutting
Material Selection and Die Cutting Costs
9/28/2017

PVC Foam Tapes: Material Suppliers and Trade Names

arrow-right

JBC sources PVC foam tapes from a strategic network of suppliers and adds value to your projects through roll slitting and die cutting. Find PVC foam tapes.

Adhesives Die Cutting Foam and Elastomers
PVC Foam Tapes: Material Suppliers and Trade Names